Turbo blower installation, maintenance and troubleshooting guide

When installing the turbine blower, it is necessary to pay attention to the concentricity error between the spindle and the motor shaft, which should be controlled within 0.05mm, and the foundation bracket must be equipped with porous rubber damping pads to reduce vibration and noise. The air outlet should be equipped with an insect-proof net and a 5° inclination angle should be reserved to prevent rainwater from backing up. During routine maintenance, it is recommended to clean the impeller surface of dust and check the integrity of the sound-absorbing cotton to maintain a low noise level below 55dB. In case of rotor jamming failure, the removable back cover injects special lubricating oil into the shaft sleeve, and cooperates with the soft start function of the PLC control system to achieve a smooth restart at 1% starting current. For the common "hum" problem of capacitor start blower, it is necessary to give priority to the capacity of the starting capacitor, if the capacity is less than 80% of the rated value, it needs to be replaced, and use a multimeter to test the resistance value of the starting winding to ensure that there is no short circuit or open circuit in the coil. This model supports RS485 remote monitoring, and users can obtain real-time data such as flow, pressure, and temperature through the LCD panel to achieve fault warning and energy consumption optimization.